Authors: Millan, E; Mota, N; Guil-Lopez, R; Pawelec, B; Fierro, JLG; Navarro, RM Article. Catalysts. vol: 10. page: . Date: SEP. 2020. Doi: 10.3390/catal10091071. Abstract: The performance of bifunctional hybrid catalysts based on phosphotungstic acid (H3PW12O40, HPW) supported on TiO(2)combined with Cu-ZnO(Al) catalyst in the direct synthesis of dimethyl ether (DME) from syngas has been investigated. We studied the effect of the HPW loading on TiO2(from 1.4 to 2.7 monolayers) on the dispersion and acid characteristics of the HPW clusters. When the concentration of the heteropoliacid is slightly higher than the monolayer (1.4 monolayers) the acidity of the clusters is perturbed by the surface of titania, while for concentration higher than 1.7 monolayers results in the formation of three-dimensional HPW nanocrystals with acidity similar to the bulk heteropolyacid. Physical hybridization of supported heteropolyacids with the Cu-ZnO(Al) catalyst modifies both the acid characteristics of the supported heteropolyacids and the copper surface area of the Cu-ZnO(Al) catalyst. Hybridization gives rise to a decrease in the copper surface area and the disappearance of the strong acidic sites typical of HPW nanocrystals, showing all hybrids similar acid sites of weak or medium strength. The activity of the hybrids was tested for direct DME synthesis from syngas at 30 bar and 250 degrees C; only the hybrids with HPW loading higher than 1.4 monolayers showed activity for the direct synthesis of DME, showing that the sample loaded with 2.7 monolayers of heteropolyacid had higher activity than the reference hybrid representative of the most widely applied catalysts based on the combination of Cu-ZnO(Al) with HZSM-5. In spite of the high activity of the hybrids, they show a moderate loss in the DME production with TOS that denotes some kind of deactivation of the acidity function under reaction conditions..